garageCube

artoladigital · by **artoladigital** » Tue Dec 16, 2008 6:07 am

can you make qt movies out of what you made in Modul8?

mowgli_uk · by **mowgli_uk** » Tue Dec 16, 2008 12:10 pm

artoladigital · by **artoladigital** » Tue Dec 16, 2008 3:44 pm

Would you have a link to instructions on that?

mowgli_uk · by **mowgli_uk** » Tue Dec 16, 2008 4:30 pm

...the manual

artoladigital · by **artoladigital** » Tue Dec 16, 2008 4:36 pm

I looked in the manual. I could not find it. can you be more helpful? pretend I am a friend who is asking a direct question.

renaud · by **renaud** » Tue Dec 16, 2008 6:28 pm

menubar : render => capture to disk

recordInG and renderInG chapter in the documentation

reno-

artoladigital · by **artoladigital** » Wed Dec 17, 2008 4:01 am

thank you, I have tried this; the manual is not clear on using modul 8 to make qt for use in other programs aside from modul8
...only capturing from outsources--not directly making a qt

artoladigital · by **artoladigital** » Thu Dec 18, 2008 6:01 am

ok saw how to do this. seemed to work fine except the rendering stops right before it finishes. I tried this with several projects...all under a minute in length. It freezes on a frame and stays there and I need to force quit. any suggestions? I looked through the message board and this seems to be a common issue. I tried several suggestions to no avail.
Is disk warrior my only solution?

Bucharest · by **Bucharest** » Thu Dec 18, 2008 9:55 am

I think it is a limitation of your hardware because if your computer have lower specs on it.... the rendering takes a long time or is freezing.And ... depends what format you chose and what codec you used with how many frames. But to be honest I am trying on my dual G5 with 8 GB Ram and a 10.000 rpm and I am not happy about the results. I tried a lot of codecs and formats and frame rates and it is freezing or I am loosing a lot of frames....so it's maybe a limitation of the software not a really hardware problem,because in my case I can consider that I got some good specs on my computer.For some reason I do not see that many people commenting about this problem ,I asked some questions in the past with no answers about what it is wrong with this picture...and I am still confused not an answer so far that it solved any of the problems that I had in the past....and I still have.

david · by **david** » Thu Dec 18, 2008 4:16 pm

Hello artoladigital,

which version of Modul8 are you using ? 2.5.8 ? What is you hardware configuration ?

Thanks.

David

garageCube

qt

Who is online