Page 1 of 1
Rotate and move
Posted: Fri Dec 17, 2004 10:56 am
by Peppe
This might be a stupid question but...
I have a clip that I rotate 90 degrees this is ok, but I also want to move the clipe to the left and right so that I can see the layers underneath. Kind of a matrix but with different clips. I hope someone understand what I´m trying to achive here...
TIA // Peppe
Re: Rotate and move
Posted: Fri Dec 17, 2004 7:19 pm
by yves@garagecube
Peppe wrote:This might be a stupid question but...
I have a clip that I rotate 90 degrees this is ok, but I also want to move the clipe to the left and right so that I can see the layers underneath. Kind of a matrix but with different clips. I hope someone understand what I´m trying to achive here...
Please could you elaborate a bit... I'm not sure I understand exactly what you mean.
Yves.
Posted: Fri Dec 17, 2004 7:28 pm
by gmint
I think I get what you're saying and I don't think there should be any problem doing it if you just scale down the clip and use the grid to move it around (and repeat with other clips).
Posted: Fri Dec 17, 2004 8:23 pm
by Peppe
Thanx gmint it was exactly what I was getting at. I was so tired yesterday I didn´t even think about the grid option.
Like I said it was a really stupid question...
//Peppe