garageCube

Hi Guys

I have rendered all the clips in 320x240 and each time I choose a clip it will be shown just half because the output resolution is 640x480. Is it possible to switch the normalize button already on when I create a new layer? I'm afraid that I will forget to switch it on, on a gig and for my purpose it should be always switched on.

thx

Same here, i render at 512x384 (half of 1024x768) and get the same problem.
An option in preferences would be handy.

an answer to your this issue is to use the master scale property bar and zoom until you reach the correct size.then each time you'll load a media at half resolution it will be displayes at the correct size.

You can also use the "default layer" module (on the online library)