garageCube

Hi there,

first of all this might be the wrong forum, but as far as I know, there is no Junxion forum. So I hope to find some answers here.
I'm trying to get my head around the configuration of my logitech attack 3 joystick with Junxion 4.6

For instance:
press button 1 >> x/y/z-axis of joystick change x/y/z-axis of selected layer in modul8
release button 1 >> x/y/z-axis of selected layer stay in current location
Whenever another button is pressed/released, another parameter in modul8 is altered [transformer, fx, color,... properties] through the x/y/z-axis of the joystick.

Through trail&error, I made some progress but didn't get near to what I imagined.
Any help is more then welcome!

Thanks in advance

There are exellent tutorial videos on Junxion site. J is rather powerful tool, so it has many ways to get your result. I programmed the Attack following the tutorial with ease. If you get to the understanding of the program you can program very complex and precise results.

hi ! I'm trying the JUNXION DEMO VERSION because I founded a LOGITECH EXTREME 3D PRO joystick and want to use it with modul8. I'm following the VIDEO TUTORIAL on STEIM
but in the junxion's pannel "Inputs HI Device Events" the joystick's raw data aren't changing when I use the buttons of the joy. However I can see the keyboard's values changing when I press keyboard's keys.

Is this a limitation of the demo or do I forget something ?

Did you plug in your joystick>start Junxion>clicking on HID events?
I see all all buttons and controllers active with my Logitech Attack 3. I am not sure if all kinds of joysticks work with mac. This may be the issue here instead.

In demo mode you cannot save any setups, and the program will only work for 20 minutes every time you start it.

Thx for your rapid answer !

Yes I do ! But no value changes ! I can see the name of the joystick in the JUNXION's HI Events panneI. I think the joystick works because I tried with USB OVERDRIVE and it works well. When I open JUNXION a message tell me that JUNXION will only work 2 hours per sessions.

I have had some problems with other joysticks8than Attack 3), so it may still be the problem with yours and mac.

you're probably right, I have to test JUNXION with another joystick before to continue, I come back here as soon as I have new results !
thank you very much vanakaru !

. if you have an xbox 360 joystick (w/the USB port) - you can use Tatiebogle's xbox joystick to HID (http://tattiebogle.net/index.php/Projec ... /OsxDriver) driver *then* launch junXion and route the buttons and joysticks as MIDI to modul8.

. with most joysticks, they need to appear as a HID (human interface device) before junXion can use them

-james
(a nomad. )

I have a PS3 >.<

. hmm. might already be supported - http://tattiebogle.net/index.php/Projec ... Controller ?

-james
(a nomad. )

I think the joystick works because I tried with USB OVERDRIVE and it works well.

williamshaker wrote:I think the joystick works because I tried with USB OVERDRIVE and it works well.

Thank you ! l did other work since l tried this, but l'm going to keep your tip preciously because l want to take this back soon !