garageCube

[pele2010]

Hi ,

i am doing a test with more than one beamer.
1 th2go = 3 Outputs .
It´s a 180° projection in a room with 3 walls.

is this a setup where i can use the spacial scan?

Or is the spacial scan only for one projector and one wall ?

Or do i need to do 3 spacial scans all from the position of the beamer
and stich the picture later together.

i´m going to do the test the next days and i´m trying to figure out which the
best workflow could be.

any help would be great .

thanxs

pele

center

zentral_mit_rechts.jpg (158.91 KiB) Viewed 3908 times

The attachment zentral_mit_mitte.jpg is no longer available

left

zentral_mit_links.jpg (161.33 KiB) Viewed 3907 times

[ilan]

You need to spatial scan with each projector separately. It is how the following project was done:

http://www.madmapper.com/2011/08/18/cat ... james-day/