I've been having a bit of an aggravating issue with my Modul8 installation lately. I don't so much think that the problem is Modul8's fault as I think (hope) that someone here may have some suggestions as to how to address this issue. The problem is this: I have an installation with six outputs using Advanced Output. I get everything setup the way I want and it works as expected, then at the end of the night, the Modul8 machine stays on but the projectors and monitors go off. When I power the projectors and monitors back up the output numbers have changed and my composition is on the wrong displays. Now, I did not have this problem when I was using all VGA outputs, but now that I have switched to using five HDMI and one VGA sources, what I imagine is happening is that the HDMI outputs are causing a re-sync which rearranges everything. As a result, I have to manually go in and rearrange the outputs EVERY DAY, which is getting to be a bit of a PITA.
Has anyone dealt with this before? Any suggestions on how I might lock this down?
Any thoughts would be greatly appreciated!