garageCube

Posted: **Fri Feb 08, 2019 11:24 am**

Hello,
I would like to remote MM using ShowCueSystems or another software installed on the same machine.
How will I configure it ???

OS: Windows

Posted: **Wed Feb 13, 2019 11:53 pm**

There's no problem about it. You can set IP to 127.0.0.1 and setup the same port number in MadMapper / Preferences / OSC and in your control software (as the output port). If your application also supports OSC input, be sure to setup a different port for this one. Only one application is supposed to open the same port on the same machine (at least you avoid possible issues doing so).

garageCube

using OSC to remote MM on the same machine as client

using OSC to remote MM on the same machine as client

Re: using OSC to remote MM on the same machine as client