Fixture Led Barre
Posted: Fri Jan 10, 2020 1:31 am
Hello everyone, I have a problem in creating the fixture for 2 of my new lights: the "LED IP Bar 320/8 RGB DMX IP65".
My problem is the following : the bar is cut in 8 RGB led segments so far no problem, creation of an 8 pixel wide fixture with 3 channels except that...the LED bar has 26 and not 24 channels, it has a channel "Dimmer for all led" in 1 and "strobe" in 26.
-Is there a technique to exclude some channels during a repetition on several pixels because mad only proposes to me to distribute the channels on the different pixels but does not allow me to make it work independently..
THX...
My problem is the following : the bar is cut in 8 RGB led segments so far no problem, creation of an 8 pixel wide fixture with 3 channels except that...the LED bar has 26 and not 24 channels, it has a channel "Dimmer for all led" in 1 and "strobe" in 26.
-Is there a technique to exclude some channels during a repetition on several pixels because mad only proposes to me to distribute the channels on the different pixels but does not allow me to make it work independently..
THX...