Hello everyone, I have a problem in creating the fixture for 2 of my new lights: the "LED IP Bar 320/8 RGB DMX IP65".
My problem is the following : the bar is cut in 8 RGB led segments so far no problem, creation of an 8 pixel wide fixture with 3 channels except that...the LED bar has 26 and not 24 channels, it has a channel "Dimmer for all led" in 1 and "strobe" in 26.
-Is there a technique to exclude some channels during a repetition on several pixels because mad only proposes to me to distribute the channels on the different pixels but does not allow me to make it work independently..
THX...