garageCube

[scaryxpuppy]

Hi there.

Am having an issue where I minimise MADMAPPER when running in show state to my external output......

It will not allow me to RE-MAXIMIZE it...!!!

I have to show VIEW DESKTOP and then close this, and then I can RE-MAXIMIZE??

Any ideas?

PHIL M

[franz]

interesting.
We'll investigate on this.
Meanwhile, don't minimize, but use the little arrow at the top of MM sidebar to hide both input and preview output views.

[alonsorama]

i notice the same problem only occurred
when system references> dock> minimize into application icon its check


also
found that if you select more then 10 times the same area into quad input, the quad output start bouncing :s

[moizez]

It happened the same to me, in the middle of a gig! It ocurred after I disconected the vga cable with madmapper on. Everytime I opened the application it went to minimize automatically and I could not maximize it again.. had to map with modul8 alone.

[franz]

MadMapper will memorize the current setting of its main view (minimized, maximized, position...) on Quit.
So basically if you quit minimized, the next relaunch will be minimized.
We've changed this behavior in the next upcoming version.