Hi ,
i just did that on 2 Shows.
There are basically 2 Ways to do this.
1. If you use watchout as timeline and to do the geometry and the blending, you feed modul8
through the video I/O of watchout.
but there are some restrictions. You cannot trigger this signal. i mean you can but it behaves like a
camera you hock to the system.
2. You use Modul8 as the final system.
Then you need to feed watchout through the video I/O of MD8.
Now you´ve got the control of the timeline through watchout and this timeline is used as
a layer in MD8.
But you need to do the softedging and geometry in MD8 or with the projectors.
Ok . there is a 3 Method:
We also used a video switcher to switch in-between the sources. (or mixer)
As far on how exactly you connect both systems you should book an operator that has done this before.
There is a Watchout Forum:
http://dataton.com/forum/forum/2-watchout-forum/And i think it should be no Problem to get an experienced operator.
The operator is not only a technician, he also guides you through the show.
I hope this helps you
pele2010