garageCube

I'm new to MM and so far so good. I'm trying to do something that I would think is simple but can't find how to do it.

If I define two (or more) quads that partially overlap, how do I set which one is in the foreground and which one gets covered. I'm essentially looking for something like "Bring to front".

Thanks.

just reorder it in the left column where all the quads are listed

I'm finally getting back to this. I think I must be daft - I can't see any way to re-order surfaces. I've tried dragging a surface to a lower spot on the list of surfaces, but it always goes back to the original spot. So how does one re-order them?

Found it myself. I can drag and drop to re-order - just not to the bottom of the list. If I want something to go to the bottom of the list, I have to move it to second from the bottom and then move the bottom one up. Looks like a minor UI bug.