Zoom in on a surface using SHORTCUT
  • scaryxpuppy
    activ8 member
    Posts: 85
    Joined: Fri Oct 21, 2011 11:13 am

    Zoom in on a surface using SHORTCUT

    by scaryxpuppy » Mon Nov 12, 2012 3:30 pm

    Am currently re-designing an application for MADMAPPER CONTROL, using OSC, now that in the newest BETA version there is the option to TAB through CORNER PINS - this allows for very fast editing "up close and personal" to the screen surfaces.

    However, I as having a problem when it comes to ZOOMING in on a selected surface.

    The shortcut CMD+PLUS only zooms the view in as far as the actual composition canvas !

    However, if you use the actual PLUS and MINUS buttons above the output preview window, you can zoom in as much as needed.

    This ability to ZOOM right in is very useful fro precise pixel adjustment.

    Anyone got any ideas, or is it just in the new BETA version? (unfortunately my current laptop only has the BETA version on so i can't check older version history)

    Many thanks

    PHIL
  • franz
    madMapper master
    Posts: 768
    Joined: Fri Feb 18, 2005 7:05 pm
    Location: Paris, France
    Contact:

    Re: Zoom in on a surface using SHORTCUT

    by franz » Tue Nov 13, 2012 12:51 pm

    in version 1.4:
    z zoom to selected surface
    CMD + zoom in (no limit)
    CMD - zoom out
    CMD = zoom stage extends
  • scaryxpuppy
    activ8 member
    Posts: 85
    Joined: Fri Oct 21, 2011 11:13 am

    Re: Zoom in on a surface using SHORTCUT

    by scaryxpuppy » Tue Nov 13, 2012 3:17 pm

    Thanks Franz!!

    Was a case of OSCULATOR seeing CMD+PLUS without the SHIFT so it was just zooming to fit !

    All resolved

    Many thanks, and thanks for a great update 1.3 and 1.4 really good big changes

    Thanks again

    PHIL

Who is online

Users browsing this forum: No registered users and 5 guests