Page 1 of 1
Madmapper & Enttec Open DMX USB
Posted: Tue Apr 22, 2014 8:50 pm
by mupp17
Hello,
is it possible to connect Madmapper with the Enttec Open DMX USB?
Or is it only possible with the Enttec DMX USB Pro?
Thanks for your answer!
Best regards,
mupp17
Re: Madmapper & Enttec Open DMX USB
Posted: Fri May 09, 2014 8:28 pm
by cbultra
Both devices are fully compatible for sending and receiving.
Re: Madmapper & Enttec Open DMX USB
Posted: Mon Nov 17, 2014 4:17 pm
by rueangrith
i just bought Enttec open DMX USB but in madmapper DMX output device is nothing. already install FTDI 2.2.18.
Re: Madmapper & Enttec Open DMX USB
Posted: Mon Dec 15, 2014 9:16 pm
by CaseyJScalf
I recently did this. It works fine but not always out of the box.
You need to install these drivers.
http://www.ftdichip.com/FTDrivers.htm
Re: Madmapper & Enttec Open DMX USB
Posted: Wed Aug 22, 2018 10:03 am
by mad-matt
Enttec Open USB DMX is not actually supported (as of 3.5.1). It's not as reliable as Enttec Pro box and we don't want to make users life complicated. Since MadMapper 3.0 (if I remember well), MadMapper supports both FTDI drivers (Simple Serial-VCP & D2XX) so it should always work: whether you use the default macOS driver (VCP) or if you installed the D2XX driver, same for Windows (except I think the driver is not installed by default on the system)
Re: Madmapper & Enttec Open DMX USB
Posted: Thu May 30, 2019 9:45 am
by MaartenEnnik
Dear Mad-Matt,
With the Enttec pro box you mean the Enttec DMX USB Pro Interface or the Enttec DMX USB Pro MK2 Interface?
Thanks in advance
Re: Madmapper & Enttec Open DMX USB
Posted: Thu May 30, 2019 11:06 am
by mad-matt
Both Enttec DMX USB Pro & Enttec DMX USB Pro MK2 are supported (Mk2 is compatible with Pro)
Any Enttec Pro compatible USB DMX device is ok too (for instance DMX King eDMX2 Pro:
https://dmxking.com/artnetsacn/edmx2-pro)