Madmapper on tour!
  • squidden
    junior Member
    Posts: 6
    Joined: Wed Dec 18, 2013 7:53 pm

    Madmapper on tour!

    by squidden » Sat Aug 02, 2014 4:24 pm

    Hi there!
    I am trying to solve a problem. I use Madmapper for a theater production that is going on tour. The technicians have to reset or adjust the surfaces on the projection areas/sets every day. Since I have a lot of the projections on excatly the same spot I have used the same surface for most of the projections. My problem is - since I want an easy setup I don't want to reset all the surfaces - now that it create individual surfaces. I can't figure out to just set up the main areas to let my movies/photos go through. Let me say I also own modul8. The main idea is to run it through Qlab. I have attached a screenshot to show it here. I am using these 7 quads for all my projections, but not always all seven at the same time.

    Thx in advance
    Michael
    Attachments
    madmapper.jpg
    madmapper.jpg (200.66 KiB) Viewed 2468 times

Who is online

Users browsing this forum: No registered users and 12 guests