garageCube

[stocha]

Hello,
I am trying to use Madmapper with several inputs, basically switching between sevral syphon sources. Since each source is different, I need to have different input surfaces. But my output should always be mapped to the same shape.
The question is: Is there a way to copy an output surface and assign it to different input surfaces ?
Or how would people go around this, i.e different input shapes to same output map

Could not find anything on the board, hope that someone can help. Thanks

[aktion]

Use Presets .. and then switch between them .. I hope this info is enough for you to get what you are looking for.

[stocha]

Hi Aktion, thanks for the reply, but it does not solve my problem.

I will try to better explain with a simple example of what I am trying to do:

- I have two inputs. Let's say a 4:3 camera and a 16:9 camera
- I am mapping both of them onto a sofa or whatever 'slightly curved' shape on stage. I have one preset for each.
- Every time I setup the stage the sofa and projectors will be at a slightly different position. I will warp the output of my surface accordingly.

And here is what I do not find a way to do. Once I warped for one of the presets, how can I just copy the warping to other surfaces/presets .
Is it at all possible ? Else this would be afeature request for me

Thanks