garageCube

[panicoescenico]

Has anybody tested to send OSC Messages from Qlab 3 to Madmapper, i can't get to make them listen one to the other.

i know with lxconsole (light control software) the syntax to send a GO message is /cmd.lxconsole/GO 1

i'm interested in sending OSC to control fixtures luminosity from Qlab i can't make work this syntax... surfaces/[selected OR surfaceName]/fixtureLuminosity (FLOAT 0.0 to 1.0)


any ideas?

[mad-matt]

Hi,
I just tested from Vezér putting an OSC float value (0.0 to 1.0) on address: "/surfaces/Fixture 1/fixtureLuminosity" and it works.
What address do you put ?
What OSC value are you sending ? (integer ? float ? string ?)
Cheers,
Matt

[panicoescenico]

i got it working now, (thanks mad-matt)

but i only can send from Qlab a single value per cue.
i'm sending float

p.e.
Cue 1 -> /surfaces/Fixture 1/fixtureLuminosity 0,0
Cue 2 -> /surfaces/Fixture 1/fixtureLuminosity 1,0

Without Vezer (only with Qlab) i don't know how to automate something as a fader or a curve.

I don't know much about OSC control commands

[mad-matt]

Hi,
I don't know QLab but I'm sure QLab support will direct you to the right tutorial.
Cheers,
Matt