this is my last try to figure out what is going on with my Software/Hardware setup.
Simply, my Enttec is not coming back to MadMapper DMX output. It was working fine two weeks ago.
What i did so far:
- checking/ installing driver FTDI, enttec shows up in the system profiler
- terminal check with page 15 http://www.ftdichip.com/Support/Documents/AppNotes/AN_134_FTDI_Drivers_Installation_Guide_for_MAC_OSX.pdf
- reinstall everything again, madmapper also
- Arena is able to run the enttec device, Millumin also, MM2.2 not
- installed helper 2xx, nothing changed
kextstat | grep com.FTDI
153 0 0xffffff7f8313c000 0x7000 0x7000 com.FTDI.driver.FTDIUSBSerialDriver (2.3) <134 39 5 4 3 1>