garageCube

Hi Peoples,

this is my last try to figure out what is going on with my Software/Hardware setup.
Simply, my Enttec is not coming back to MadMapper DMX output. It was working fine two weeks ago.
What i did so far:
- checking/ installing driver FTDI, enttec shows up in the system profiler
- terminal check with page 15 http://www.ftdichip.com/Support/Documents/AppNotes/AN_134_FTDI_Drivers_Installation_Guide_for_MAC_OSX.pdf was good
- reinstall everything again, madmapper also
- Arena is able to run the enttec device, Millumin also, MM2.2 not
- installed helper 2xx, nothing changed
any ideas?
thanks, alexander


results:
151114_:

terminal request
kextstat | grep com.FTDI
153 0 0xffffff7f8313c000 0x7000 0x7000 com.FTDI.driver.FTDIUSBSerialDriver (2.3) <134 39 5 4 3 1>

Hi Alexander,

MadMapper uses the VCP driver installed natively in Mac OSX. I suppose Millumin is using D2XX. Both driver cannot run at the same time.
There is an application to switch driver: http://macdownload.informer.com/ftdidrivercontrol/

I suppose it will solve.
Cheers,
Matthieu - MM team

PS: for fast support use our support system