I was wondering if you have found the solution for your project? I have a similar question and was wondering how to go about it. Did u manage to use a Kinekt with madmapper?
Thanks in advance
M
Hello!
I have been asked to create an interactive wall (about 3m x 4m) where the audience touches a certain part of the wall and the animation gets triggered at the spot as well as some sound. What I have found so far is that you can use Kinekt with Processing but I haven't found any example of such installation with Madmapper. If you have any thoughts, suggestions or links of tutorial etc I would really appreciate it. Thanks again!!
AD
There are better sensors than a kinect for the example in the video.
If the spots are that specific you could use peizo sensors/buttons to detect through the wood.
We did this once with a bench and tinfoil on the bottom through 2cm of wood was enough to detect someone sitting.
So it was just a teensy and a bit of tinfoil a resistor and 2 cables.
There are very cheap sensors you could use that in most circumstances gives you a better and more stabile input as for instance a kinect would.