Mesh disappearing after calibration even when low calibration error
  • jhamonemillion
    junior Member
    Posts: 3
    Joined: Wed Mar 06, 2019 1:35 pm

    Mesh disappearing after calibration even when low calibration error

    by jhamonemillion » Thu Mar 14, 2019 5:20 pm

    I keep encountering a really annoying and erratic behaviour when calibrating my meshes. Once I put in my 6th point the mesh just disappears, and I am left with 6 red dots. However, my margin for error is very good (less than 15px).

    Is there something I am doing wrong? Annoyingly, *sometimes* - say once out of every 10 attempts - it works, but with no pattern I can discern.
  • franz
    madMapper master
    Posts: 699
    Joined: Fri Feb 18, 2005 7:05 pm
    Location: Paris, France
    Contact:

    Re: Mesh disappearing after calibration even when low calibration error

    by franz » Wed Mar 20, 2019 7:58 pm

    this usually happens when there's a "relatively big" difference in measurements between the model and the real object.
    It works "usually" perfectly when using a mesh and its 3d printed version (== exactly the same measurements)

Who is online

Users browsing this forum: No registered users and 1 guest