I recently bought an Advatek PixLite 16 Mkii LED strip controller. It's really convenient for running a lot of light strips, and has additional DMX outputs to use for other fixtures.
However, the only way these extra outs will work is if you use sACN to control the lights. I've tried just about everything I can think of within MadMapper and the Advatek assistant but I can't seem to get sACN to work.
I realize sACN support is pretty new to this software, so maybe this isn't supported.. I did get it working over ArtNet, but that means I'm not able to use my other outputs. I'm still demoing MadMapper, and would love to buy the software, but if it means I can't use sACN I'd probably need an additional DMX node and my budget's a bit tight
Any advice on this would be amazing! Thanks!