Outputting DMX to 2+ controllers
  • Raphael
    junior Member
    Posts: 8
    Joined: Wed Jul 25, 2018 11:17 pm

    Outputting DMX to 2+ controllers

    by Raphael » Fri Mar 22, 2019 3:01 am

    I have a DMX output setup with 2 separate controllers connected over ethernet (Pixlite 4 Mk2). Unlike when routing through USB, where I can assign different universes to different USB controllers, I don't see the option to do so for ethernet controllers. In short, I'd like to route a set of universes to controller A, and the other to controller B. How do I do that?
    Attachments
    Screen Shot 2019-03-21 at 9.00.12 PM.jpeg
    Screen Shot 2019-03-21 at 9.00.12 PM.jpeg (93.06 KiB) Viewed 367 times
    Screen Shot 2019-03-21 at 8.57.20 PM.jpeg
    Screen Shot 2019-03-21 at 8.57.20 PM.jpeg (121.56 KiB) Viewed 367 times
  • mad-matt
    garageCube team
    Posts: 879
    Joined: Mon Sep 09, 2013 5:50 pm

    Re: Outputting DMX to 2+ controllers

    by mad-matt » Mon Mar 25, 2019 3:19 pm

    You disabled ArtNet Polling. Just check the option "Auto Poll for devices" below the ArtNet unicast table and you'll see your two Pixlites. MadMapper will automatically send the universes where needed (ArtNet polling lets us know who's on the network and which universes devices are listening to)
  • Raphael
    junior Member
    Posts: 8
    Joined: Wed Jul 25, 2018 11:17 pm

    Re: Outputting DMX to 2+ controllers

    by Raphael » Thu Mar 28, 2019 2:25 pm

    Thanks! It was driving me crazy. :D

Who is online

Users browsing this forum: No registered users and 2 guests