garageCube

hey everyone,

i´m on this for some hours now, looking at everything twice to make sure that its not me not seeing the wood for the trees. here´s the problem:

when i mask something in madmapper - wether by adding a mask-layer or using a mask in a quad - the masked areas are not showing up as masked in the ouput.

any idea whats going wrong here? i attached two pictures (one from the preview output, one from the output)

a little addition to that:

after shutting down madmapper and restarting the masking is now showing up in both preview output and output. seems to be a little bug in general, because i experienced this problem within a few days both on my macbookpro and my imac. anything i can send you guys from garagecube that will make this traceable? logfiles or something?

ok, it starts to get funny:

when i add a mask to a mapping, then import some movie-content, play it, change the content, the mask disappears. o_O

Hello visualprime,

Be great if you could send your message to support [at] garagecube [dot] com. This way we can verify if it is a bug and address the issue with our next update.

ilan wrote:Hello visualprime,

Be great if you could send your message to support [at] garagecube [dot] com. This way we can verify if it is a bug and address the issue with our next update.

done