garageCube

Hello,

I am testing madmapper (demo mode) to check if it fits my needs.
I have an artnet led array I used to drive through a Dmxking box or OLA daemon. Both are configured in Artnet II so I am using my own subnet (192.168...).
On the fixture DMX screen, I have Artnet Output/ Artnet not configured.
I was wondering if configuration is automatic and if my problem is due to using my subnet (vs 10.10.....) ?
Is-it possible to use DMX fixture on my subnet ?

Thanks for your help,
Regards,
Christophe.

are you confusing artnet subnets with subnet mask?

No, I am using unicast which is part of Artnet 2 I think.

Regards,
Christophe.

Hello,

I did more investigation and the problem was coming from my universe configuration.
Now, it was working.

Regards,
Christophe.

Hello,

I setup my led array (46x10 - contiguous universes) using multiple fixtures. Everything seems correct, but I have some artifacts. Randomly, some fixtures blackout for a few seconds. I attached the screen capture.



Any idea from where the problem could come from ?

Regards,
Christophe.

are you using MadMapper demo ?
the demo randomly blacks out fixtures.

Yes I am using the demo version.

Thanks for your help,
Regards,
Christophe.

Sorry we should have said that more clearly when downloading the demo.

It's written on at the bottom of the specs page: http://www.madmapper.com/madmapper/specs/