Hello,
is there a way to limit the artnet output rate to a specific value (in Hz)?
My artnet fixtures are sensetive to high framerates (over 50Hz).
Greets
Janson wrote:No, my fixtures have direct artnet input, but madmapper has a high framerate output which fills the buffer of their network interface too fast. The processor which is an Atmel 8Bit can't process the packets so fast.
I'm currently in contact with the developer of it. He said that all other software products have abilities to limit the framerate and are able to use artnet unicast.
Janson wrote:Yes, it's the LED stripe artnet node.
It works well on Arduino MEGA (because of its processing power) but causes hangs on UNO on large packet bursts. We are currently debugging the problem with the developer.
Users browsing this forum: No registered users and 20 guests
Copyright 2017 © garageCube. All Rights Reserved. Powered by phpBB® Forum Software © phpBB Limited.