garageCube

Hello madmappies,
I'm sending osc messages from max to madmapper
It works "fine" but there is only feedback from my messages
for example i'm sending " /surfaces/moulin/opacity $1 "ranging $1 from -0.421 to 1,702 gives me opacity 0% to 100%
and the message is automatically forwarded to my listening port which is fine but when change the slider in madmapper interface nothing is coming back.
Is this normal or do i miss a parameter??
Thank you
cheers
H

I just check with TouchOSC and it works fine (getting feedback when changing opacity with the mouse). Are you sure you are not listening to the same port you are writing on ? In that case you would receive your own messages, and not MadMapper ones...
Matthieu