garageCube

Hi Everyone

A couple of days ago, I was using Syphon Recorder (latest) to record MadMapper (latest) output, either streamed from M8, or a video clip and it worked fine. Now I prepare my mesh in MadMapper, output is good then I open Syphon and the output flickers or blinks dramatically. I quit Recorder and MM continues to blink. If I switch to internal camera in MM, that doesn't blink. Choose M8 or video clip, blink is back.

Can not figure out what changed. I have tried all the variations I could think of in Recorder and MM without luck. New projects, different output in Recorder… I sent this problem to the Syphon list too.

Any advice greatly appreciated!

John

-OSX 10.6.8-

Same here.

Worked without any problem in OSX 10.7 until I upgraded to Mavericks 10.9, newest Syphon recorder b13, and MadMapper 1.6.3

But the problem is not Syphon recorder, when I use MadMapper version 10.5.3 it works....

Please try to fix guys!

Thanks for the input. Nice to know it is not all my incompetence.

John

After mailing with the support team, I got following answer:

There's a frame synchro issue with MadMapper 1.6.3 that causes black and white frames with Syphon.
We will fix that soon.

Thanks for your report

Gael
GarageCUBE Team