garageCube

I made a big, ugly, meaningless png to use as a mask to just see if I can overlay it on the output and do some soft edges on my projection. As you'll see by my picture below... It's a mess of a map. I'm edge-blending four projectors that are all turned in various directions on an uneven surface. The new edge blending in the Beta version helps... but without soft edges on a mask, I can't make this all work just yet.

So.... That mask that I did on the output.... It's not affecting anything. I can't see it on any of my outputs... even though it's clearly there on the preview.

Any ideas?

~Ian

The mask is drawn over the stage, so if you move the projectors out of the stage, you won't see the mask.
But you should see it, for me it works. If it doesn't you can PM me your project.
Cheers