Hey
I'm wanting to control some SGM LB100 balls via artnet, I've been supplied madrix but it's no where as good as I hoped. So hoping I can map in madmapper. They have artnet in / out, generally the signal chain is out of the ethernet port, into the SGM TLD612a. It's mapped in madrix, there are no extra artnet convertors or anything. I can't for the life of me get anthing to work... The only clue is on the "artnet unicast routing table" it says "artnet interface uninitialized"
I've set a manual IP to the same range as the SGM, I have selected the right intereface and tried to add the fixture in DMX output via ip.
SGM:
http://sgmlight.com/products/tld-612-a/c-23/p-194#
http://sgmlight.com/products/lb-100/c-23/p-149
Any suggestions? Am i barking up the wrong tree...
Thanks
Ryan