garageCube

[lamepantallas]

Hello MadMappers,

I am getting this real annoying problem where I go to full screen for the output and I keep getting a window which is visible during my show, instead of the full screen. Before, all I did, once the projectors where connected and detected was press full screen and that is it. Now when I do that, the output screens comes with a window I have to drag outside my screen for it be seen. I have tried detect displays, full screen at startup, mad mapper preferences, etc, and have not had any luck with it.

Is anyone else having this problem? Is it apple problem? Is there a way around it?

Thanks guys!


g.

[franz]

what version are you using ?

[lamepantallas]

MadMapper 2.01
OSX Yosemite 10.10.5

[franz]

never had this problem.
maybe it comes with yosemite ?
do you have a menu bar on each screen ? if so, switch your os to have the menu bar only on the main screen

[mad-matt]

It means you have a projector that is not connected to a screen in your project. Btw, update to 2.1.

[lamepantallas]

Ok, thanks guys. It has happened mostly when I am using the triplehead2go. Yet, if it is not connected to the screen of my project, then why am I getting a full output of my screen through the projectors?

Thanks again!

g.

[mad-matt]

When you start MadMapper there is always a window for each projector on your desktop. You can close it. In fullscreen mode, this window is replaced by a fullscreen view if the projector is assigned to a screen. That's it.