garageCube

[vuruzvision]

Hello all,

I just did my first LED mapping set up with madmapper, I was successful to map the 8 LED strips to an input, however when I use MadLine and animate a line going from left to right, The LED strip does not produce the light sequence which goes from left to right! but only it lights the whole strip.

I have uploaded a video to demonstrate the problem, follow the link :
https://www.youtube.com/watch?v=v-G2pwt ... e=youtu.be

Equipment i'm using:

-24 Channel LED DMX Driver :
http://www.amazon.com/Channel-Decoder-D ... 12+DECODER

-Enttec DMX USB Pro
-Mean Well power supply


Hope someone can help!

[Xaver2k]

you are uing analog led strips. and analog led strips can only light up the full strip or nothing. you need digital led strips and a controller for them, take a look for "digital led strips" and then you can choose between many different protocols like WS2801, WS2811 etc...
(the controller is dependent on what protocol your leds strips will support)

[vuruzvision]

By controller do you mean the DMX decoder? and regarding the digital LED strips do you have a good source to purchase them?

Thanks for the help


ive got this decoder, would it work? http://www.amazon.com/Channel-Decoder-D ... 12+DECODER

[Xaver2k]

check these post maybe its enough information:

viewtopic.php?f=21&t=9375

viewtopic.php?f=21&t=9256

viewtopic.php?f=20&t=9238

viewtopic.php?f=20&t=8975

viewtopic.php?f=21&t=8914