Hello,
Longtime user.. finally posted on the forums with a question..
I'm trying to map out nexus 4x4 LED panels (and have had no problem doing that on te madmapper end).
However, my video source is syphon in from Resolume and I'm attempting to control Resolume from the GrandMA2 (both via artnet)
If i start Mad MApper before Resolume, there are no problems with mad mapper outputting the artnet to the console. With ArtNet IN disabled on MM side, Resolume will not allow me enable Artnet for console control..
HOWEVER... If I start Resolume first, and then MM, Resolume works fine from the console, but MM will not output Artnet to the console.
I feel like the two are colliding somewhere, and I've tried everything from different subnets to different network interfaces all together but neither seem to work. I've also tried Unicast, etc..
ANY IDEAS??
Thanks!