garageCube

I have searched for an hour or so but can't seem to find anything relevant. I have created my first madmapper projector and movie by creating a 3d image of my house and than adding images and video clips onto different locations. I create the .mov file using syphon, however I do not hear any of the sound which goes with the movie clips.

Do I need to enable something or do the sound with a different program?

Any advice would be greatly appreciated.

I have checked to make sure that the sound is not muted, that the original video clips do indeed have sound, etc.

Thanks!

Are you using MadMapper 2 ? In this case you have to enable audio in the movie settings (below the media list).
If it doesn't help, does enabling hardware acceleration help ?

That was it, I knew it must be something simple as toggling something!

Thanks a ton, its greatly appreciated!