The input is OK, but the output makes all transparency 0 or 100%.
I have some blending(blur) in between, all blur appears to be white 100%
input window
output window
what will be the correct way to do this inside mad mapper
Alpha conversion between input and output
-
Alpha conversion between input and output
I have used DXV3 codec from resolum in after Effect on mac.
The input is OK, but the output makes all transparency 0 or 100%.
I have some blending(blur) in between, all blur appears to be white 100%
input window
output window
what will be the correct way to do this inside mad mapper -
Re: Alpha conversion between input and output
no one have a idea on this -
-
franz
- madMapper master
- Posts: 1080
- Joined: Fri Feb 18, 2005 7:05 pm
- Location: Paris, France
- Contact:
Re: Alpha conversion between input and output
are you using the premultiply alpha blend mode maybe ? -
Who is online
Users browsing this forum: No registered users and 33 guests
Copyright 2017 © garageCube. All Rights Reserved. Powered by phpBB® Forum Software © phpBB Limited.