Page 1 of 1

Programmable controller for ws2813 led

Posted: Fri Jun 03, 2016 11:10 am
by daisy1988
ws2813 ledis ws2812 updated version,it has dual-signal wires version , signal break-point continuous transmission,does rfduino suit for it?thanks.
ws2813 led datasheet is http://www.normandled.com/upload/201605 ... asheet.pdf

Re: Programmable controller for ws2813 led

Posted: Mon Aug 22, 2016 8:44 pm
by mad-matt
it should be ok yes. do you want to drive it with MadMapper LED output through USB ?

Re: Programmable controller for ws2813 led

Posted: Tue Jun 05, 2018 4:00 am
by daisy1988
Yes,i want to drive it by MadMapper,but i have no experience about it,can you help me?i also want to control GS8208 LED by MadMapper?

Re: Programmable controller for ws2813 led

Posted: Fri Jun 08, 2018 10:06 pm
by mad-matt
If you want to make a serious project, or if you don't want to spend time soldering cables, you can go for an Advatek Pixlite or similar LED controller. MadMapper sends ArtNet (network DMX) packets, and the Pixlite read ArtNet and drive the LEDs (it supports many LED protocols)