garageCube

Hi,

I work normally with a pre-mapping of a building facade for example, i create my surfaces and build the show with a lots of scenes at home. Once i am installed on site with the beamers, i need, of course, to adapt the OUTPUT geometry of my surfaces.

It would be very very helpful and great to have a button to adapt this changes (= x,y coordinates of the 4 corners for each surface) in ALL scenes (and maybe cues)

...or do i miss something ?

THANX in advance

modify your geometry,
select all your cues, enter "edit cue" mode,
in your surface inspector tab (left panel), "output geometry" should be orange,
click it once to turn it red, exit "edit cue" mode.
done

WOAW, THAT'S EASY

GREAT !

Thanx