As a wish - it would be great to have a HOTKEY to toggle through the 4 corners of a selected Quad.
I use a Wii controller linked via Osculator to control my cursor when mapping remotely on site, and sometimes if my initial projection is overshooting the surface, it is difficult to spot the corners of a Quad
If I could use a HOTKEY (such as TAB) that is allocated to a Wii button and his would speed up the process.
Obviously, I think it would be too hard and maybe a bit excessive to be able to toggle through MESH WARPS, but the basic 4 corners of a surface would be great
Here's hoping
Phil