Been struggling all day long trying to properly configure my bcr2000 to work with modul8 the way i want.
to make it short:
i need to get the knobs to act "relatively" and not in an absolute form.
to be more clear: if a layer is in 50% opacity, and i want to take it down to zero, how do i make the knob to take it from 50 down and not from the controller's knob value? (right now - if it's in 90, the layer will jump from 50 to 90 and then will go down).
i was able to program it to REALATIVE1 mode, yet it behaves weird, when i'm turning the knob - while the value on the controller is moving up, the opacity slider on the modul8 jiggles back and forth, like it's stuck in place.
how can it be done?