garageCube

I'm playing around with Contextual Midi and wanted to change an assignment only to find that the assigment was 'stuck' and would not respond to delete or backspace key.

Take a look if you can.

Can you eleborate a bit please ?
What exactly control it was was 'stuck' ?
Could you save a file (menu File -> save as) and send it to support@garagecube.com ?
(The contextual midi config is saved inside file project)

Thanks

I linked a control dial (0/10 - I think) to the luma standard radio button. it was an accident - that i wanted was the cc to go to the luma on/off so that i could turn it on with any non-zero input from that knob and off with zero. So I reassigne to the luma/on off toggle but then could not remove the earlier assignment.

I don't have the file handy but will email it to you later.

I had something similar happen. I was asigning a MIDI controller to an effect and my Mac and the machine hung for about 30 seconds. I can't reproduce it though!

Sean
________
extreme vaporizer

Thanks for the file skyvat,
Modul8 1.0.1 is available now (in a few minutes) !
And this problem is now fixed

I forgot,
you must just remake your midi contextual config !
...