Setting up a tripleheadtogo
  • shcptechdirector
    junior Member
    Posts: 1
    Joined: Sat Dec 14, 2019 2:38 am

    Setting up a tripleheadtogo

    by shcptechdirector » Sat Dec 14, 2019 2:43 am

    On page 94 and 95 of the manual it says that I do not need to use advanced controls if I have a tripleheadtogo. It says to go to modul8 preferences and select the preview panel, where I will get 5 options.
    I cannot find the preview panel in the preferences, nor anywhere in the menus.

    My tripleheadtogo is set up without problems and works with QLAB no problem. I just need modul8 to see the second screen in its super wide aspect ratio.


Who is online

Users browsing this forum: No registered users and 3 guests