Page 1 of 1
how do i authorize?
Posted: Mon Sep 15, 2008 3:57 am
by queglay
i just purchased modul8 however it doesn't ask me for my auth code when i start it up. when i click "update my reg info" that all works, but i still can't save files.
is there anything i can do to reset the authorization status and defaults?
thanks for any help.
Posted: Mon Sep 15, 2008 8:42 am
by david
Hello queglay,
are you using the demo version ? What does the "License to :" field of the About dialog (Modul8 | About Modul8...) says ?
David.
Posted: Mon Sep 15, 2008 10:06 am
by queglay
under licensed to is blank. im using the full version of 2.5.7
I'll admit that i tried a cracked version for a few days before i just bought the full version yesterday.
Posted: Mon Sep 15, 2008 6:55 pm
by vanakaru
You may want to find all M8 related files and remove them before running and serializing you new version again. And do you activate over the internet?
Posted: Mon Sep 15, 2008 7:10 pm
by david
Hi all,
In this case, the solution was to deauthorize Modul8 (this will invalidate the cracked serial) and then go through the normal authorization procedure (online or offline).
David.