garageCube

I have a logo that I would like to make into a bug that will be located in the lower right hand side of the screen. When I am using the transformer button to wrap and spin the logo it does not sit "straight on" in reference to the screen.

It is straight on when it's in the middle of the screen, but whenever you move them to corners, they want to sit off at an angle.

What am I missing?

Thanks all

Use the small knob in the center of the transform controls. The one right in the middle of the x, y, z knobs. This will flatten the field of view so you have a parallax view of your layer.

You rock. I tried every one BUT that one I think. Thanks!!

You're welcome.