garageCube

when i change parameters on different layer sets, changes are made
in every layer set. It only happens in group B.

example
when preparing set up:

layer set 1 (one picture on the screen): Group A - 2 layers -Grid center
Group B - 2 layers - Grid center

layer set 2 (two pictures on the screen) : Group A - 1layer - Grid left
1 layer - Grid right
Group B - 1layer - Grid left
1 layer - Grid right


after setting layer set 2 i went back to layer set 1 and encounter this

layer set 1 (one picture on the screen): Group A - 2 layers -Grid center
Group B - 1layer - Grid left
1 layer - Grid right

layer set 2 (two pictures on the screen) : Group A - 1layer - Grid left
1 layer - Grid right
Group B - 1layer - Grid left
1 layer - Grid right

Any solution?

Hello,
just to be sure to understand well...
Do you use the upstairs and downstairs buttons for your changes ?
(Upstairs button is for the group A and downstairs button for the group B)