garageCube

[jojosback]

Greetings all.. I'm trying to get my live cam feed to work in Modul8. I'm using the easycap device and videoglide software to recognize it on my mac. I am getting the feed into videoglide. However, when I try to switch the video capture source in Modul8, I see Videoglide listed, but I cannot select it. Any suggestions?

Thanks

[VJnutcracker]

Hi.

http://www.garagecube.com/forum/viewtopic.php?t=3951

This thread may help.

What USB device have you got?

[jojosback]

Hi VJnutcracker.. I am using the EasyCap device with videoglide software. Again, I am getting the video signal into the computer but Modul8 will not allow me to select the source in video settings

[VJnutcracker]

from that thread..".EasyCap DC60+ v.3.1B. [thanks vanakaru] - 720x576 Pal, 720x480 NTSC. (not the DC60 v.2.1C - make sure it has a + sign after the DC60) "

[vanakaru]

Try to make sure that no other app is using the EasyCap. You do not need to run VideoGlide to get this dongle to work in M8. I hope this helps. And try restarting M8 or your mac. If you see live image with Videoglide or QT you should get it to M8 as well.

[viberation]

Thanks, I was fiddling with my EasyCap DC60+ for over an hour, no matter what I did it was grayed out in Modul8.

Then I restarted my MBP, and *did not open the Video Glide software*. Just opened Modul8. It started working, Thanks!!!