garageCube

[littleradiohead]

hello! new here - not sure if this is the right place for this question, but i'm getting pretty frustrated from a few hours of searching on google.

i have a MBP running 10.6.1 and I cannot get 'live' or 'dynamic' audio to output of out m8 whatsoever.

I can load in quicktime files and get my sound to output just fine, however I cannot get my internal microphone to output, nor playing a tape through a DV deck

I have adjusted the sound input and output knobs on the lower right corner, I can see my audio input in my system preferences and I just tried the sound viewer tool module and it shows the volume levels in my mic.

but for the life of me, i can't get the audio to output to anything!

[mowgli_uk]

What do you mean "get the audio to output to anything"?

The audio input is only for fx control etc NOT to record or route incoming audio.

[littleradiohead]

Whenever I play a clip of something, the audio will output to my speakers, or my line-out or whatever I have it set to.

If I have incoming live audio through firewire - or through a MOTU - it does not output.

Is there a setting I'm missing somewhere?

Thanks for your response!

[anomad]

. i use motu digital performer so i *think* i know what you're asking...

. you'll need a sound pass through application to 'route' sound to your system's audio out . i use soundflower1.5.1 on os x10.6.2 -BUT - it craps out about every 45 minutes or so.

. when using audio in, make sure the the audio in knob in the main interface of modul8 is turned up.