How to change default frame rate for PNG sequences ?
  • cliptrax
    junior Member
    Posts: 2
    Joined: Sat Jun 12, 2010 3:40 pm

    How to change default frame rate for PNG sequences ?

    by cliptrax » Thu Jun 24, 2010 2:03 pm

    I have a question concerning the default framerate for PNG sequences. Every time i load a PNG-seq. it will say in the info that it has a framerate of 5 fps. Is there any way i can change that? I need them to play at 25 fps without changing the speed in the layer or global.

    Any help with this is greatly apprechiated.

    Bitman (video editor at CliptraX, Amsterdam)
  • User avatar
    sigmasix
    master
    Posts: 1224
    Joined: Thu Dec 02, 2004 2:12 pm
    Location: gva | switzerland
    Contact:

    by sigmasix » Thu Jun 24, 2010 3:07 pm

    This is something we discussed a lot when we implemented it. Some user will prefer to use these folder medias for slideshows, others for time lapse. Se we decided to use 5fps so it's a kind of average. But we see now it's a bit too slow for time lapse. We are thinking of adding a multiplier value over the speed slider so it can go way faster. We don't really want to implement it on a "per media" basis as you might want to have one going like 5fps on one layer and 25 fps on an other…
    We will implement it for the next release.
  • cliptrax
    junior Member
    Posts: 2
    Joined: Sat Jun 12, 2010 3:40 pm

    by cliptrax » Thu Jun 24, 2010 6:41 pm

    Thank you very much for the quick response and the very satisfying answer. I like using exported PNG sequences from chroma keyed video, because of the very clean output i get from Ultimatte-advantedge.
    You guys doing a fabulous job with M8, looking forward to the next release. 8)

Who is online

Users browsing this forum: No registered users and 6 guests