BCR2000 Manual Programming?
  • User avatar
    Plastik7
    junior Member
    Posts: 4
    Joined: Mon May 30, 2005 4:37 pm
    Location: Israel
    Contact:

    BCR2000 Manual Programming?

    by Plastik7 » Mon Aug 16, 2010 9:52 pm

    Been struggling all day long trying to properly configure my bcr2000 to work with modul8 the way i want.

    to make it short:

    i need to get the knobs to act "relatively" and not in an absolute form.
    to be more clear: if a layer is in 50% opacity, and i want to take it down to zero, how do i make the knob to take it from 50 down and not from the controller's knob value? (right now - if it's in 90, the layer will jump from 50 to 90 and then will go down).

    i was able to program it to REALATIVE1 mode, yet it behaves weird, when i'm turning the knob - while the value on the controller is moving up, the opacity slider on the modul8 jiggles back and forth, like it's stuck in place.

    how can it be done?
    P7
  • newdendrite
    member
    Posts: 16
    Joined: Thu Aug 05, 2010 6:00 pm

    by newdendrite » Wed Aug 18, 2010 7:31 am

    I'm also have a critical need to program relative positioning for the BRC2000. Could someone post a small example in Python of how to do it for just one knob? Then we could take it from there. I'd REALLY appreciate it!

    Thanks,
    Michael

Who is online

Users browsing this forum: No registered users and 41 guests