Page 1 of 1
Posted: Sat Dec 04, 2010 12:22 am
I have some problem with the mapping of surfaces, I can not map multiple 'forms of a and b, how can I do to add more' than 10 layers in the same clipout?
thanks for the help
Posted: Thu Dec 09, 2010 11:15 pm
What technique are you using to map?
Are you using MapMap Module or through a photo mask?
If it is through a photo mask, Id recommend you map using the global mask module, for it is easy for you to change the mask (yo can have any number of masks or combinations of it)and have all ten layers free to mix and manipulate video with the selected mask.
Re: video mapping
Posted: Fri Dec 10, 2010 7:43 am
kobaiashy wrote:I can not map multiple 'forms of a and b, how can I do to add more' than 10 layers in the same clipout?
you cant have more than ten layers - use two computers
as for A&B - duplicate layers and move them to another bank
Posted: Fri Dec 31, 2010 12:01 am
You could record your performance with 10 layers - logical record / logical render - put it back M8 and then perform over that - logical record / logical render again.