garageCube

[pele2010]

Hi there,

is there a way of mapping midi to the filters section ?

i would like to map a control dial of a midi interface to the dial of the filters

let´s say i want to map the dial of the blur intensity to a dialer

and then in a other filter set like gloom i want the same dial to react to
the intensity of the gloom effect.


here 2 pictures from the filters modul:

[img]http://modul8.eachfilmtransfer.de/02_.png
[img]http://modul8.eachfilmtransfer.de/01_.png

would be great to here that there is a solution for the
mapping problem.

(i did try all three modes , focus,position,layerset+position)

thanx Peter

[pele2010]

Question:

-Do i have to write a Module to achieve this ?

- Is their no Answer to my Question?

thnaxs

pele2010

[ilan]

If you know specifically which filters and what parameters of those filters you want to use I would advise creating a custom module to do this. Just a few knobs will do. You should also check on the public section as there may already be something simple like this that you can just customize a bit to your liking. You should not have to write any fancy code for it, but you might still want to refer to the online module manual.

http://www.modul8.ch/documentation/modules_manual/

[allofitnow]

Use the "(at) Filter (layer)" module in the online public library. It allows mapping then head over to http://collectedconsciousness.wordpress.com/ and make a small donation.